Military Technology

"...

"First of all, we need to conduct a very careful physical examination of the 'Oasis-1 Inflatable Space Experiment Module' that has been sent into space to confirm whether it is malfunctioning.

We know that during the rocket launch and ascent, there will be relatively strong vibrations. Although spacecraft and rockets have already done similar shockproof designs, it is difficult to ensure that spacecraft with complex and sophisticated internal structures will not malfunction due to vibration.

Therefore, we need to conduct a very detailed physical examination of the entire space experiment module, and only start the following work after confirming that there is no problem. "

So is it possible to carry out related experiments? Susie asked.

Wu Hao shook his head with a smile: "Not yet, after ensuring that there is no problem with the 'Oasis-1 Inflatable Space Experiment Module' and that it is in a normal state, we need to start a precise orbit change and attitude adjustment.

No matter how advanced a rocket is, it is impossible to send a satellite or spacecraft to a precise orbit all at once. We need to control the spacecraft or satellite so that it can reach the precise orbit we require.

Of course, if the rocket is good enough and the orbiting accuracy is high, it will greatly save the fuel on the spacecraft or satellite, thereby increasing and prolonging the operating life of the spacecraft and satellite.

However, if the rocket does not send the satellite or spacecraft to the predetermined orbit, or if the deviation from the predetermined orbit is large and far, then when the orbit is changed, the fuel consumption on the spacecraft and the satellite will be relatively large, so that It will lead to a significant reduction in the in-orbit operating life of satellites or spacecraft.

Judging from the published orbital data, the orbital accuracy of this launch is still very high, and only a small adjustment is needed.

Secondly, we have to adjust the inclination angle of the spacecraft. On the one hand, it is convenient for the solar panels on the "Oasis No. 1 Inflatable Space Experiment Module" to form an optimal angle with the sun to fully absorb sunlight and provide space for spaceflight. device for power supply.

Secondly, the communication antenna on the spacecraft must also be adjusted to facilitate the connection between it and the ground. This time, we will establish a high-speed and large-capacity communication network with the spacecraft, so that we can receive high-definition video images from multiple camera positions inside and outside the "Oasis-1 Inflatable Space Experiment Module" on the ground.

These pictures will also be announced to the public at a later date.

After all these are completed, we will start to inflate the folded space experiment module at the right time, so that it will start to expand and return to its normal state. "

"Then how long do you expect this 'Oasis-1 Inflatable Space Experiment Module' to start inflating? Everyone is very concerned about this now." Susie continued to ask.

"Soon, soon. If everything goes well, we will start to inflate the 'Oasis One Inflatable Space Experiment Module' tonight.

The whole process will last two and a half hours, and the time will be longer.

At that time, we will also announce its latest news in real time. "Wu Hao replied with a smile.

Hearing Wu Hao's answer, Susie looked down at the transparent tablet in her hand, then smiled at Wu Hao and asked, "The netizen 'Wind in the Painting, Dreamer' asked why it took so long to inflate. Why not fill it all at once like blowing up a balloon."

Hehe, Wu Hao laughed: "Hehe, the principle of this 'Oasis No. 1 inflatable space experiment cabin' is a bit like blowing a balloon, but it is not a real balloon.

We blow up the balloon, at most it will scare you, and then replace it with a new one and continue blowing. And if our "Oasis No. 1 Inflatable Space Experiment Module" blows up, it will not be so easy to replace it.

It is precisely because of this that all missions in space are relatively cautious and extremely careful. Otherwise, if there is a failure, it will be difficult to repair, and even if it can be repaired, the cost will be very high.

Secondly, this "Oasis One Inflatable Space Experiment Module" is our first experimental spacecraft. Although we have repeatedly verified it several times, we still need to be more cautious.

After the relevant verification is safe and reliable, and there are no problems, we can use the rapid inflation method in the subsequent inflation of the inflatable inflatable space capsule, and the entire process will be shortened from the current two and a half hours to half an hour. "

"Netizen Uchiha Haruzuki asked, is this 'Oasis No. 1 inflatable inflatable space experiment capsule' really safe? I heard that there is a lot of space junk in space, and it is difficult to prevent it. Such an inflatable experiment capsule will not be destroyed. These space junks crashed."

Hahahaha... Hearing this question, Wu Hao laughed, then put down the coffee in his hand and shook his head with a smile: "No, we have already made full preparations on how to prevent space junk.

In order to ensure the safety of the "Oasis-1 Inflatable Space Experiment Module", we must avoid those orbits with a lot of garbage, and the selected orbits must be safe and clean.

Secondly, we are also paying close attention to the orbital situation. If there are space junk debris, it may pose a threat to our "Oasis One Inflatable Space Experiment Module".

Then we have to take measures, such as changing the orbit of the "Oasis No. 1 inflatable space experiment module" to avoid the threat of these space junk debris.

Finally, on our "Oasis-1 Inflatable Space Experiment Module", we also used a lot of related technologies to ensure that its safety performance is no worse than those of space stations and spacecraft.

First of all, we use high-molecular high-strength and high-toughness composite materials. This material is very thin, and the thickness of a single layer is only 0.2 mm.

We stack these materials like paper to form a composite material, and then stack them.

After repeating this several times, a very strong polymer composite material can be obtained, and its strength and toughness can be several times stronger than that of steel.

Secondly, we filled a special liquid in the shell of the "Oasis-1 Inflatable Space Experiment Module". Once there is a leak in the "Oasis No. 1 inflatable space experiment cabin", the liquid will automatically flow to the leak point, automatically repair the leak, and ensure the pressure balance in the cabin.

This new method also avoids the embarrassing situation where leakage points appear in traditional space stations and are difficult to find. "

Hehehehe... Hearing what he said, Susie couldn't help laughing. These days, she has been scrambling to learn about spaceflight, so she naturally knows who Wu Hao's eccentricity and insinuations are about.