Fake Extinction of All Mankind, and I Rebuild Civilization with my Bare Hands was Broadcast Live

soon.

After some calculation tests.

Make sure there's nothing wrong.

Jiang Kui picked up the tool immediately.

Start making mortise and tenon on the three force~arms!

structure like this.

The best tenon-and-mortise connection.

It is to adopt the method of single-insertion through tenon and tenon reduction!

This tenon is often used to connect the overlord tent with the table legs.

To enhance the stability and firmness of the table legs!

The principle just applies to the lever arm of the crank handle!

The method is simple.

Place the two lever arms at a 45-degree angle to the main lever.

One end has a hook tenon.

Push up after inserting the tenon hole.

Push the tenon up with the wedges below.

form a hook.

The other end is connected with the bottom surface of the noodles with a pin.

Except for the pins.

Always keep the mouth against the belt.

to position the lever arm!

As such.

The main arm and the two direct force arms can be built closely together!

If replaced with ordinary straight tenon.

There is no way to achieve this effect!

Straight tenon is simple though.

But for such a large fortification.

The structure is still too simple!

with prolonged use.

It is very likely that the moment arm will break!

Adds a lot of unnecessary trouble.

But this kind of mortise and tenon does not.

In a blink of an eye.

A morning passed quickly.

With crank handle and winch.

Basic hardware for cranes.

Basically it's over.

Next, just cast the pulley and the wire.

Install it in a given location.

A sophisticated original crane.

Can be put into operation!

The production of pulleys and iron cables.

Still using clay mold casting method.

but.

Because the specifications have to meet the requirements.

After the part has cooled.

It also needs to be carefully polished.

Especially the iron buckle on the iron cable.

when pressing the mold.

It is necessary to reserve a gap in advance.

When they are connected in series, use a hammer and other tools to tighten the fracture on each iron ring.

It's not that difficult.

But it took a lot of effort.

It took nearly three hours.

The relevant parts were installed on the corresponding position of the crane by Jiang Kui!

follow closely.

After all parts are in place.

The iron rope is also ready.

Take out the triangular ladder.

Jiang Kui hung it on the pulley.

then.

The iron cable extended from the pulley again.

Wrapped around the winch in circles.

Fasten at last.

"Phew! It should be fine..."

After all this was over, Jiang Kui breathed a sigh of relief.

Install the crank handle immediately.

Randomly found a log of a hundred kilograms.

Pull the wire on the lower pulley.

Secure the log.

Then back to the winch.

Get off your horse.

Shake off your shoulders!

Both hands eagerly grasped the handle.

Shake it with all your might!

"Crash--!""

Every push.

The iron rope on the crane made a fine metal collision sound!

soon.

Circle after circle.

With the rolling of the cable.

A miracle occurs!

The log was easily hung up!

【Fuck!!!!】

[…]

【I join! Congratulations to Lord Kui, entering the mechanical age!】

【Oops!!! He pretended to be there again!】

【66666! Give me a fulcrum, I can lift the earth! 】

【Too awesome!】

Eagle sauce audience: [Oh my god!!! I really can't imagine that this guy actually built a crane with his bare hands! 】

Dongying audience: [Brother's craftsmanship is so amazing! 】

Korean audience: [Axi! Who am I? Where am I? What did I see?]

have to say.

Full mortise and tenon winch!

It's no worse than a steel structure!

Because the connection is tight enough.

Even if the maximum centripetal force is full.

There will be no surprises!

The only fly in the ointment is that the swingarm's operating range is a bit over budget due to the weight of the lever arm.

It can take some effort to control!

Handling is a bit poor.

But no problem.

The purpose of building a crane.

Just to control the wooden sluice in the reservoir!

besides.

There are hardly any other special uses.

The winch of the crane has a switch to terminate the gear teeth.

The principle of the switch design is the braking principle of the wooden cow and the horse.

When the heavy object reaches the predetermined height.

Turn on.

This stops the internal gear teeth from working.

Very convenient.

"Big white! Get out of the way."

Just tested it.

I think there is no problem.

Jiang Kui waved his hand and drove away the curious Da Bai.

Then shake the winch again.

Put down the log hanging in the air.

The crane is built right next to the pool.

The purpose is to facilitate the control of the gates.

The sluice is in the entire adjustable weir.

more important part.

Subsequent water intake and drainage.

It's all controlled by it.

There are many ways to make it.

Concrete pouring.

Reinforced concrete construction is a good treatment method.

But for Jiang Kui.

The wooden gate is definitely the best choice!

Simple to make.

High practicality!

save time and energy.

These advantages alone.

Problems such as easy corrosion and water leakage can basically be ignored!

Build sluice gates.

Need to drive stakes in the pool first.

Design the slide for the gate!

The slide is supported by wooden stakes.

Either on or off.

It can make the wooden gate very stable.

0

Prepare slides and stakes.

The next step is to choose the right wood.

Use a frame saw to break it down into a thick enough, big enough plank!

Polished with a plane.

It is assembled into a wooden wall using a tenon-and-mortise structure.

The top of the wooden wall is hooked up with the crane's iron olive.

Embedded slides on both sides.

By the time.

Just roll the winch.

You can easily control the opening and closing of the gate.

Realize the concept of controlling the water level in the pool.

Roughly sorted out the ideas.

Before a day has passed.

Jiang Kui didn't waste time either.

Now busy again!

Find the right wood first.

Then a slideway for the wooden gate was created inside the reservoir.

Then build the stakes.

Supported on both sides of the slide.

The outside is fixed with iron rope traction.

As such.

The stakes provide maximum protection for the slides.

Relieve stress.

Extended service life.

There are slides.

The gate itself is simpler.

Feel free to use wood that fits your size.

Break into planks.

Assemble it together.

Hang on a crane!

Then, use the power of the crane to lift the wooden gate.

Find the location.

into the chute.

Such and such.

Busy until late at night.

A very primitive wooden gate divides the pool into two!

Let the adjustable weir have the ability to control the flow of water in and out!

(Second update, ask for votes!) Righteousness.