Doomsday Bunker Upgrade

Chapter 576: The Hollowed Mobile Base

In the base's hangar, the huge mobile base has lost its original appearance.

The upper deck has been almost completely taken apart, and the interior space has been emptied, from the top deck to the bottom garage, and the middle compartment has also been removed.

If the mobile base before dismantling was a behemoth that looked full of deterrence and power, after dismantling, it was already just a huge metal frame.

Although not all parts were emptied, only the upper hangar, the public space of the personnel cabin and the garage on the ground floor were emptied, but this still made the whole mobile base look much thinner.

"Academician, the space that has been emptied is still unable to accommodate the weather controller!" A staff member stood next to the mobile base with the blueprint, and said to Chen Xin with a wrinkled face: "According to the current calculations, at least It takes three times as much space to put the current weather controller in, which is simply impossible!"

Although the staff has been reducing the size of the weather controller as much as possible during this time, so far, even if many unnecessary parts have been removed, it is still a behemoth that cannot be placed in the mobile base at all.

Of course, Chen Xin also knew this, and he didn't say anything special about it, he just nodded his head to show that he knew, and said, "Don't worry about this, first install the fusion reactor on the mobile base.

As for the weather controller, first find a way to reduce the volume of each part, it is really impossible to expand the volume of the mobile base! There are always more ways than difficulties, step by step. "

"Okay, academician." The staff also understood the truth, so they nodded and went to work on their own.

On the other hand, Chen Xin walked into the mobile base that had been basically demolished.

This is one of the two mobile bases he upgraded and transformed when he was in Siberia before.

But now this one, with most of the internal structure removed, is about to serve as a carrier platform for the weather controller.

The bottom garage originally used to house the vehicle will be used as the installation location of the energy transmission and conversion module, and the surging energy produced from the small fusion reactor will be input into the weather controller to provide sufficient energy for the weather controller.

It might sound like it would be possible to directly connect a fusion reactor to a weather controller, but it's not actually possible to do so.

The fusion reactor manufactured by Chen Xin uses magnetofluidic power generation, which is different from traditional high-temperature boiling water. It uses ionized gas to pass through a strong magnetic field at a high speed. Positively charged ions and negatively charged ions are affected by the Lorentz force in opposite directions. Deflected, each falls on opposite electrode plates, forming the positive and negative poles of the power supply.

The benefits of this are of course obvious, to achieve continuous production of nuclear fusion raw material gas intake-heating-reaction-exhaust-power generation-product separation-unfused nuclear recovery and reuse.

But at the same time, although this reduces the requirements for the reaction vessel, there are certain requirements for the electrical power, because if the output of such high power cannot be supported, the line will be overloaded and burned.

Therefore, some equipment is needed to bind and tame this violent flood-like electricity, making it more docile, before it can be sent to the weather controller.

This is like high-voltage electricity cannot be connected to household appliances, and it needs a transformer for conversion.

Moreover, although the weather controller requires a considerable amount of energy during operation, this energy cannot be directly connected to the machine with the current just output from the fusion reactor, so there is a high probability that the machine will be burned directly.

The energy transmission and conversion module, on the other hand, is also a safety measure for the weather controller to prevent the machine from malfunctioning or being damaged due to current problems.

It is also out of this consideration that in addition to building a nuclear power plant for the weather controller as a power supply facility, the Suvians also prepared a dedicated substation and transmission lines for the weather controller.

But when installed on a mobile base, nuclear power plants can be replaced with small fusion reactors, and variable power plants are not so good.

Fortunately, the convenience brought by the development of science and technology is not only the increase in power generation, but also the substation equipment can be made smaller.

Chen Xin vacated the garage on the ground floor, which is intended to be used to house the energy transmission and conversion modules that have been upgraded with modern technology.

Today's technology has advanced a lot from the Suvian era, and the garage of the mobile base can accommodate these modules.

In addition to these auxiliary equipment, the weather controller itself still has many other modules. The volume of these modules is not small at all, even if the public space of the personnel cabin of the mobile base, the upper hangar and the top deck are all vacated , but it is still difficult to install the behemoth of the weather controller.

Not to mention, the antenna used by the weather controller to transmit microwaves is a behemoth with a diameter of more than 50 meters. Although it can be erected outside the top deck of the mobile base, it is still too large and difficult to install.

It is difficult to install just one antenna, let alone the coil used by the weather controller to generate microwaves. It is a huge circular coil with a diameter of more than 100 meters. Unless the structure is changed, it cannot be stuffed into the mobile base. .

Moreover, the weather controller has more than these two parts, and the protective cover that needs to be installed in order to prevent the microwave from escaping needs to cover the entire machine...

Therefore, even though the interior space of the mobile base that has been emptied now is vast and is no less than the hangar of a heavy aircraft carrier, it is still difficult to stuff such a huge thing as a weather controller.

Chen Xin must find a way to reduce the size of the weather controller, or expand the interior space of the mobile base.

Fortunately, both of them are not difficult for him. As long as he uses the system upgrade, it can be done in an instant.

What the mobile base has to do here is to enlarge and elongate it to expand the internal space, but the weather controller is not easy to handle.

After all, even if the system upgrade can be completely controlled by Chen Xin's cognition and thoughts, Chen Xin is not a true professional after all, and it is difficult to guarantee that the upgrade route he chooses must be the best.

Therefore, it is safe to wait for researchers to come up with a suitable plan, and then upgrade the weather controller according to the plan so that it can be placed in the mobile base.

Now the mobile base side doesn't need major changes, and the weather controller side needs to reduce its size little by little.

Tap the screen to use advanced tools Tip: You can use left and right keyboard keys to browse between chapters.

You'll Also Like